News center
【概要描述】Learn how disc springs provide axial preload for bearings, reduce axial clearance, and improve the stability of rotating machinery.
【概要描述】Learn how disc springs provide axial preload for bearings, reduce axial clearance, and improve the stability of rotating machinery.
In rotating machinery, axial clearance in bearings can lead to unwanted movement, vibration, and reduced positioning accuracy.
One effective solution is to use disc springs (Belleville washers) to apply a controlled axial preload to the bearing assembly.
Disc springs provide a compact and reliable way to maintain constant contact pressure, helping reduce axial play and improve the stability of rotating components.
A typical arrangement places a disc spring between the outer ring of an angular contact ball bearing and the supporting housing.
When the disc spring is compressed, it generates an axial force that continuously pushes against the bearing outer ring.
This preload helps:
Eliminate unwanted axial clearance.
Maintain stable bearing positioning.
Reduce vibration and unwanted movement.
Improve the accuracy of rotating assemblies.
When an external axial force exceeds the spring preload, the spring can undergo additional deflection, allowing controlled axial movement.
Proper disc spring selection is essential for achieving the required preload and operating performance.
The following parameters should be considered:
Outer Diameter (OD): Must fit within the available housing space.
Inner Diameter (ID): Must accommodate the shaft or supporting structure.
Thickness: Influences the load capacity and spring characteristics.
Deflection: Determines the working compression range.
Spring Force: Must provide sufficient preload without overloading the bearing.
Available Installation Space: Determines the number and arrangement of disc springs.
The spring force should be evaluated at the actual working deflection rather than simply using the maximum rated load.
When a single disc spring cannot provide the required load or deflection, multiple springs can be combined.
Two common arrangements are used:
Parallel Arrangement
Disc springs are stacked in the same direction. The total load capacity increases, while the deflection remains approximately the same.
For n identical springs:
Total spring rate = n × K
Series Arrangement
Disc springs are alternately stacked in opposite directions. The total deflection increases, while the load capacity remains approximately the same.
For n identical springs:
Total spring rate = K / n
Where K represents the spring rate of a single disc spring.
The actual performance of a stacked assembly may also be affected by friction, contact conditions, and manufacturing tolerances.
By selecting the correct spring dimensions, load characteristics, and stacking arrangement, engineers can improve the stability and performance of rotating machinery.
Raleigh Spring specializes in disc spring manufacturing, offering customized dimensions, materials, and load characteristics to meet different industrial application requirements.
Contact us to discuss your disc spring requirements.